The manual states that pan positions are kept when bouncing. So far all my attempts have proved otherwise. I'm panning the three tracks all to different places in the mix so I can listen to the results but they all end up in the middle! Can anyone help?
Ta
TA: Make sure that after getting the pan to you liking, be sure and press "exit" to retain these settings. On my PS-02, I have to refer to the manual quite often, but it does work.
JOHN
thanks harmony
March 30 2002, 9:01 PM
I'll give it a whirl
Dempsey
OK
March 30 2002, 10:22 PM
The PS-02 will only retain the pan settings if you bounce to a stereo track(eg. 2+3). Then after you bounce you must pan track 2 fully to the right and track 3 fully left(or visa versa). Most people forget this last step and accidently leave their original pan settings. Good luck!
john
Re: Bouncing?
March 31 2002, 11:26 AM
Cheers,
I didn;t even know about the last bit!! Didn't see it in the manual at any rate, that must've been where I was going wrong because I was recording to 2 and 3
